g***@gmail.com
2006-08-28 21:11:45 UTC
Hi,
I bought a used Sun Blade 100 which has Solaris 10 pre-installed. But I
need to run an application which only runs on Solaris 8. I downloaded
Solaris 8 4/04 media and I start with Volume 1. Everything seemed work
fine until when the disk is partioned and ready to intall, I got the
following error message on console there after:
##messages after /sbin/startinstall
WARNING: /***@1f,0/***@d/***@0,0 (dad0):
Aborted Command
WARNING: timeout: reset bus chno = 0 targ = 0
WARNING: /***@1f,0/***@d/***@0,0 (dad0):
disk not responding to selection
WARNING: /***@1f,0/***@d/***@0,0 (dad0):
offline
##messagers after disk is partitioned and ready to install
Preparing system for Solaris install
Configuring disk (c0t0d0)
- Creating Solaris disk label (VTOC)
ERROR: Could not create Solaris disk label (VTOC)
WARNING: /***@1f,0/***@d/***@0,0 (dad0): offline
ERROR: Could not label disks
ERROR: Could not update disks with new configuration
Could not update disks with new configuration
Here is what probe-ide shows:
Type 'go' to resume
ok probe-ide
Device 0 ( Primary Master )
ATA Model: Maxtor 6Y080P0
Device 1 ( Primary Slave )
Removable ATAPI Model: HL-DT-STDVD-ROM GDR8163B
Device 2 ( Secondary Master )
Not Present
Device 3 ( Secondary Slave )
Not Present
What could be wrong? any pointers will be greated appreciated.
Jian
I bought a used Sun Blade 100 which has Solaris 10 pre-installed. But I
need to run an application which only runs on Solaris 8. I downloaded
Solaris 8 4/04 media and I start with Volume 1. Everything seemed work
fine until when the disk is partioned and ready to intall, I got the
following error message on console there after:
##messages after /sbin/startinstall
WARNING: /***@1f,0/***@d/***@0,0 (dad0):
Aborted Command
WARNING: timeout: reset bus chno = 0 targ = 0
WARNING: /***@1f,0/***@d/***@0,0 (dad0):
disk not responding to selection
WARNING: /***@1f,0/***@d/***@0,0 (dad0):
offline
##messagers after disk is partitioned and ready to install
Preparing system for Solaris install
Configuring disk (c0t0d0)
- Creating Solaris disk label (VTOC)
ERROR: Could not create Solaris disk label (VTOC)
WARNING: /***@1f,0/***@d/***@0,0 (dad0): offline
ERROR: Could not label disks
ERROR: Could not update disks with new configuration
Could not update disks with new configuration
Here is what probe-ide shows:
Type 'go' to resume
ok probe-ide
Device 0 ( Primary Master )
ATA Model: Maxtor 6Y080P0
Device 1 ( Primary Slave )
Removable ATAPI Model: HL-DT-STDVD-ROM GDR8163B
Device 2 ( Secondary Master )
Not Present
Device 3 ( Secondary Slave )
Not Present
What could be wrong? any pointers will be greated appreciated.
Jian